Advanced Boiler Fault Finding Course
The Get Training Fault Finding Course is aimed at existing gas engineers or ACS approved gas operatives including newly qualified ACS engineers, who are looking to enhance their practical skills with further technical support on boiler maintenance, fault finding and repair.
Avoid wasting money throwing cash at boilers because you have misdiagnosed the fault. Our technician will train you how to use your multimeter properly to diagnose faults. Understand resistance with sensors, continuity, NTC & PTC circuits, check components on PCB boards. You will be trained on electrical safety and how to check for polarity faults which could affect the flame rectification circuit. If you have opted for a career as a breakdown engineer or just want to brush up on your fault finding skills then this is the course for you.
Note if you have your own multimeter then bring it along and we will show you how to use it, if you haven’t our highly skilled trainer will demonstrate a recommended model.
Course contents:
- Fault finding logic sequence
- Be able to trace a fault from a particular point in boilers start up sequence
- Fully understand the interlocks and how to diagnose the faults using a multimeter
- Test down to component level to measure resistance to determine a good bad scenario
